Armour Detail Supply PHOBIC Spray Coating - 90 ml | User Friendly Ceramic Coating

PHOBIC Spray Coating is Armour's most user-friendly ceramic coating! It integrates the exceptional benefits of traditional ceramic coatings in a convenient spray format, making advanced paint protection easier than ever before.

• Next-generation, high solids chemistry forms an exceptionally slick and hydrophobic barrier
• Use on paintwork, trim, plastics and glass
• Provides up to 2 years of durability
• User-friendly spray-on application

Leveraging the advanced high-solids chemistry of Armour Quartz coatings, PHOBIC employs next-generation silazane resins to form an exceptionally slick and hydrophobic barrier on paintwork, trim, plastics, and glass. Despite its simple application, PHOBIC provides up to 2 years of durability and delivers the full spectrum of ceramic coating benefits, including superior chemical resistance. PHOBIC can be used as a standalone solution of as part of your existing ceramic coating maintenance regimen. 

Shield your vehicle's finish with PHOBIC Spray Coating, where simplicity meets exceptional performance.

Prep:

The prep is the most important step of the process, PRO Quartz is great but it cannot do the prep work for you!

1. Decontaminate the paint surface using Armour Detail Supply Decon Soap and Iron Remover, followed by removing further embedded contamination with a clay bar or synthetic clay mitt.
2. Optional: If swirl marks, or scratches are present, polish the paint to reduce any surface defects and create maximum gloss.
3. Use Armour Detail Supply Panel Prep to remove any oils/residue left from your polishing step. If you did not polish the surface, repeat this step twice to ensure a clean surface.

Application:

1. After thorough prep, prime an applicator or short nap microfiber towel with 10-15 sprays to start. Each subsequent application will only need 3-5 sprays, a little goes a long way.
2. Apply PHOBIC 1 panel at a time using overlapping circles making sure to have even, level coverage. Allow product to "set up" for 30-60 seconds depending on temperature/humidity. Look for uniform small sweat beads or slight hazing to appear before removing.
3. In a similar circular motion, level the coating using a plush towel. Check for any streaks, or high spots which can appear as cloudy or dark spots. Repeat this process per panel.
4. Use a fresh side of the plush leveling towel every other panel. The application towel/pad can be used over the whole vehicle.
5. Once finished, remove spray pump from bottle and rinse thoroughly with water or alcohol solution. Secure sealing cap on bottle tightly and store in a cool/dry place for extended use.
6. PHOBIC was designed as a single layer coating, however it can be layered. if you wish to apply multiple layers allow a few minutes between layers. this will guarantee optimal performance.

After Care:

• Allow product to sit 4 hours for initial cure. After 4 hours you can apply AMPLIFY or CERAMIC SPRAY SEALANT to protect the coating during its initial cure. Do not wash or induce to chemicals for 24 hours.

What's Included:

• (1) Armour PHOBIC Spray Coating - 90 ml
• (3) Spray Pump
• (1) Orrifice Reducer (alternative to spray nozzle)

Specifications:

• Solids Content: ~25%
• Hardness: 7H
• Chemical Resistance: High 2-12 pH
• Durability: 1-2 Years Real World
• Film Thickness: ~300nm
• Flash Time: 30-60 seconds
• Coverage: 10-15 ml per car, 15-20 ml per large vehicle
• Water Contact Angle: 110 degrees, Low Sliding Angle
• Working Temperatures: 40F - 100F
• Shelf Life: 12 months, use within 3 months of opening for best application experience. Store with cap sealed tightly in cool/dry place.

Size: 90 ml